Blackdog Wear Training Halter- Available in 2 colours

The dynamic design of the Blackdog Wear Training Halter allows the Halter to move as the dog moves, leaving the Nose Bridge strap to sit comfortably in the same position, this means it doesn't tend to ride up close to the dog's eyes and the dog is more content while wearing the Halter. Remember to reward your dog, when introducing it to the Halter and throughout the first week, particularly when you first fit the Halter and as your dog works well on lead. Fitting is simple...  Adjust the Neck Strap to fit (a tight, snug fit high on the neck is best). Take the Halter off again) Slide the Nose Strap over the dog's muzzle (reward the dog with a little treat to ease any concerns) Buckle the Neck Strap Pull down on the Lead Ring (this adjusts the Training Halter to fit the dog's face) Slide the cord lock to about 1cm below the D-Ring tab under the dog's throat Attach a lead to the O-Ring on the cord, and your dog is ready to go.                                                                                                                 

Measuring your dog for a Training Halter.

The Noseband and Cords on the Training Halter allow for a large adjustment, so the sizing is based on a dog's neck measurement

Use a soft tape measure place it around your dog's neck up close behind the ears, this is where the neck strap should fit and take a snug to tight neck measurement.

Important: If your dog fits between 2 sizes, generally select the smaller size,

UNLESS you are fitting a growing dog in which case you might go for the larger size to allow for future growth.

Check your dog's neck measurement against the chart below, to select the appropriate size.